Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeethernet-services
Examples
This example shows how to enter the PVRST Interface configuration mode:
RP/0/RSP0/CPU0:router(config)# spanning-tree pvrst st1
RP/0/RSP0/CPU0:router(config-pvrst)# interface GigabitEthernet 0/0/0/1
RP/0/RSP0/CPU0:router(config-pvrst-if)#
Related Commands
DescriptionCommand
Sets the forward-delay time for the bridge.forward-delay (PVRST), on page 505
Sets the maximum age for the bridge.maximum (PVRST), on page 541
Sets the transmit hold count performance parameter.transmit (PVRST), on page 635
Configures Per VLAN Rapid Spanning Tree (PVRST) on a
VLAN.
vlan (PVRST), on page 641
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
528
Multiple Spanning Tree Protocol Commands
interface (PVRST)
To Next Page
Loading...
Need help?
General
