This example shows how to configure the MAC flushagain timer in the EVPN Timers configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# evpn
RP/0/RSP0/CPU0:router(config-evpn)# timers
RP/0/RSP0/CPU0:router(config-evpn-timers)# flushagain 30
RP/0/RSP0/CPU0:router(config-evpn-timers)#
Related Commands
DescriptionCommand
Enters EVPN configuration mode.evpn, on page 400
Enters the EVPN Interface configuration mode.interface (EVPN), on page 410
Configures timers that affect the convergence of PBB EVPN
in failure scenarios.
timers, on page 458
Configures the recovery timer.recovery, on page 427
Configures the peering timer.peering, on page 422
Configures the programming timer.programming, on page 425
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
405
Provider Backbone Bridge Commands
flushagain
To Next Page
Loading...
Need help?
General
