Examples
The following example shows how to configure the PBB edge component:
config
l2vpn
bridge group PBB
bridge-domain PBB-EDGE
interface GigabitEthernet0/0/0/38.100
!
interface GigabitEthernet0/2/0/30.150
!
pbb edge i-sid 1000 core-bridge PBB-CORE
!
!
!
The following example shows how to configure the PBB core component:
config
l2vpn
bridge group PBB
bridge-domain PBB-CORE
interface G0/5/0/10.100
!
interface G0/2/0/20.200
!
pbb core
!
!
!
Related Commands
DescriptionCommand
Establishes a bridge domain, and enters L2VPN bridge group bridge
domain configuration mode.
bridge-domain (VPLS), on page 240
Creates a bridge group so that it can contain bridge domains and
then to assign network interfaces to the bridge domain.
bridge group (VPLS), on page 242
Enters L2VPN configuration mode.l2vpn, on page 100
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
421
Provider Backbone Bridge Commands
pbb
To Next Page
Loading...
Need help?
General
