Configuring the Satellite Network Virtualization (nV) System on the Cisco ASR 9000 Series Router
Upgrading and Managing Satellite nV Software
HC-727
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Configuration Guide
OL-26061-03
SAT101/FT0/*
host Hotspot0 56.0
SAT102/FT0/*
host Hotspot0 53.0
Reloading the Satellite Device
In order to reload the satellite device, use the hw-module satellite satellite id/all reload command.
Example
RP/0/RSP0/CPU0:sat-host# hw-module satellite 101 reload
Reload operation completed successfully.
RP/0/RSP0/CPU0:May 3 20:26:51.883 : invmgr[254]: %PLATFORM-INV-6-OIROUT : OIR: Node 101
removed
Port Level Parameters Configured on a Satellite
These are the port-level parameters that can be configured on a satellite nV system:
• Admin state (shut and no shut)
• Ethernet MTU
• Ethernet link auto-negotiation that includes,
–
Half and full duplex
–
Link speed
–
Flow control
• Static configuration of auto-negotiation parameters such as speed, duplex, and flow control
• Carrier delay
• Layer-1 packet loopback which includes,
–
Line loopback
–
Internal loopback
• All satellite access port features on Cisco ASR 9000 Series Router.
To Next Page
Loading...
Need help?
General
