Cisco A9K-SIP-700 Configuring Network Settings

Configuring the Satellite Network Virtualization (nV) System on the Cisco ASR 9000 Series Router
Configuration Examples for Satellite nV System
HC-729
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Configuration Guide
OL-26061-03
Satellite Interface Configuration
The Satellite interface can be used as any other regular GigabitEthernet interfaces:
interface GigabitEthernet200/0/0/0
l2transport
!
!
interface GigabitEthernet200/0/0/0
ip address 99.0.0.1 255.255.255.0
!
!
interface GigabitEthernet200/0/0/2
bundle id 100 mode active
!
!
Satellite Management using private VRF
You can use a special private VRF instead of the global default routing table, to configure the loopback
interface and ICLs used for satellite management traffic. IP addresses in this VRF will not conflict with
any other addresses used on the router.
router(config)# vrf NV_MGMT_VRF
router(config)# address ipv4 unicast
router(config)# interface Loopback 1000
router(config)# vrf NV_MGMT_VRF
router(config)# ipv4 address 10.0.0.1 / 24
router(config)# interface TenGige 0/1/0/3
router(config)# vrf NV_MGMT_VRF
router(config)# ipv4 point-to-point
router(config)# ipv4 unnumbered Loopback 1000
router(config)# nv
router(config-nv)# satellite-fabric-link satellite 500
router(config-nv)# remote-ports GigabitEthernet 0/0/28-39
router(config)# nv satellite 500
router(config)# ipv4 address 10.0.0.2 / 24

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English