Cisco AIR-WLC4402-50-K9 - Logging In

Installation and Configuration
Logging In
20
Cisco 4400 Series Wireless LAN Controllers - Installation and Configuration Guide
78-17157-01
Logging In
Perform the steps below to log into the controller:
Step 1 Enter a valid login and password to enter the CLI.
User:
Password:
Note The login and password functions are case sensitive. The default Administrative User login and
password are admin and admin, respectively.
Step 2 The CLI displays the root level system prompt:
(system prompt)>
The system prompt can be any alphanumeric string up to 31 characters. You can change it entering
the following command:
(system prompt)>config prompt
Because this is a user-defined variable, it is omitted from the rest of this documentation.
Step 3 The CLI automatically logs you out without saving any changes after 5 minutes of inactivity. This
automatic logout can be set from 0 (never log out) to 160 minutes using the following command:
(system prompt)>config serial timeout
Refer to the Navigating the CLI and Logging Out of the CLI sections in the Product Guide for more
information.