EasyManuals Logo

Cisco Aironet 1040 Series User Manual

Cisco Aironet 1040 Series
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
8
Note Access points mounted in a building’s environmental airspace must be powered using PoE
to comply with safety regulations.
Cisco recommends that you make a site map showing access point locations so that you can record the
device MAC addresses from each location and return them to the person who is planning or managing
your wireless network.
Installation Summary
Installing the access point involves these operations:
Performing a pre-installation configuration (optional)
Mounting the access point
Grounding the access point
Deploying the access point on the wireless network
Performing a Pre-Installation Configuration
The following procedures ensure that your access point installation and initial operation go as
expected. A pre-installation configuration is also known as priming the access point. This procedure
is optional.
Note Performing a pre-installation configuration is an optional procedure. If your network
controller is properly configured, you can install your access point in its final location and
connect it to the network from there. See the “Deploying the Access Point on the Wireless
Network” section on page 14 for details.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Aironet 1040 Series and is the answer not in the manual?

Cisco Aironet 1040 Series Specifications

General IconGeneral
BrandCisco
ModelAironet 1040 Series
CategoryWireless Access Point
LanguageEnglish

Related product manuals