Cisco Aironet 1300 Series User Manual

1
Quick Start Guide Cisco Aironet 1300 Series Access Point
Read This First
This guide is designed to help you quickly set up and configure your Cisco
Aironet 1300 Series Outdoor Access Point/Bridge.
This guide does not cover mounting the access point/bridge or establishing a
bridge link. Those subjects are covered in the Cisco Aironet 1300 Series
Outdoor Access Point/Bridge Mounting Instructions, which shipped with
your access point/bridge. You must complete the procedures in the mounting
instruction document and then use this guide to initially configure the access
point/bridge to connect to your LAN.
Important Information
Recent Cisco IOS releases have changed the way an unconfigured access
point/bridge behaves when booted for the first time. This section describes
this behavior and provides instructions on how to open‘ the access point’s
configuration pages.

Cisco Aironet 1300 Series Specifications

General

Maximum Data Rate	54 Mbps
Power over Ethernet (PoE)	Yes (802.3af)
Model	Aironet 1300 Series
Ethernet Ports	1 x 10/100 Mbps
Operating Temperature	-20°C to 55°C (-4°F to 131°F)
Dimensions	8.5 x 5.5 x 2.5 in (21.6 x 14 x 6.4 cm)
Ports	1 x 10/100 Mbps Ethernet, 1 x Console
Security	WEP, WPA, WPA2, 802.1X, AES, TKIP
Operating Modes	Access Point, Wireless Bridge, Wireless Repeater
Power Options	Power over Ethernet (PoE)

Summary

Read This First

Important Information

Details changes in Cisco IOS releases and how to access configuration pages.

Cisco IOS Release 12.2(15)JA and Earlier

Cisco IOS Release 12.3(2)JA

Cisco IOS Release 12.3(4)JA and Later

Enabling the Radio Interfaces

Checking the LEDs

Related Documents

Before You Begin

Resetting the Access Point/Bridge to Default Settings

Using the Web-Browser Interface

Details the procedure for resetting the device via the web browser interface.

Using the CLI

Obtaining and Assigning an IP Address

Assigning an IP Address Using the CLI

Details the procedure for assigning an IP address using the Command Line Interface.

Using a Telnet Session to Access the CLI

Assigning Basic Settings

Configuring Security Settings

Understanding Express Security Settings

Express Security Limitations

Configuring Advanced Parameters

Cisco One-Year Limited Hardware Warranty Terms

Replacement, Repair, or Refund Policy for Hardware

To Receive a Return Materials Authorization (RMA) Number

Provides instructions for obtaining a Return Materials Authorization (RMA) number.