To Next PageTo Next PageWhat to do if I encounter a firmware error on my Cisco Wireless Access Point?
If you encounter a firmware error, try disconnecting and reconnecting the power injector power jack. If the problem persists, it is recommended to contact technical support for assistance.
General| Maximum Data Rate | 54 Mbps |
|---|---|
| Power over Ethernet (PoE) | Yes (802.3af) |
| Model | Aironet 1300 Series |
| Ethernet Ports | 1 x 10/100 Mbps |
| Operating Temperature | -20°C to 55°C (-4°F to 131°F) |
| Dimensions | 8.5 x 5.5 x 2.5 in (21.6 x 14 x 6.4 cm) |
| Ports | 1 x 10/100 Mbps Ethernet, 1 x Console |
| Security | WEP, WPA, WPA2, 802.1X, AES, TKIP |
| Operating Modes | Access Point, Wireless Bridge, Wireless Repeater |
| Power Options | Power over Ethernet (PoE) |
