ix
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
OL-5048-02
Preface
This section describes the objectives, audience, organization, and conventions of the Cisco Aironet 1300
Series Outdoor Access Point/Bridge Hardware Installation Guide.
Objectives
This publication explains the steps for initial setup and basic configuration of the Cisco Aironet 1300
Series Outdoor Access Point/Bridge supporting 2.4-GHz operation. This publication also provides
troubleshooting information and detailed specifications.
Audience
This publication is for the person installing and configuring the Cisco Aironet 1300 Series Outdoor
Access Point/Bridge (called the access point/bridge) for the first time. The installer should be familiar
with network structures, terms, and concepts.
Organization
This guide contains the following sections:
Chapter 1, “Overview,” describes the major components, features, and specifications of the access
point/bridge.
Chapter 2, “Installation Overview,” provides warnings, safety information, and information needed
before you begin the installation of your access point/bridge system.
Chapter 3, “Mounting and Alignment Overview,” provides an overview of components and features used
during access point/bridge mounting and antenna alignment operations.
Chapter 4, “Using the Web-Browser Interface,” describes how to use the web-browser interface to
configure the access point/bridge.
Chapter 5, “Configuring the Access Point/Bridge for the First Time,” describes how to enter basic access
point/bridge configuration settings.
Chapter 6, “Using the Command-Line Interface,” describes how to use the command-line interface
(CLI) to configure the access point/bridge.
Chapter 7, “Troubleshooting,” provides solutions to potential problems encountered during setup.
To Next Page
Loading...
