Cisco APIC M4 User Manual

Figure 12: Reversing the CMA
Metal button on outside of tab2CMA tab on end of width-adjustment slider1
Initial Server Setup
This section describes how to power on the server, assign an IP address, and connect to server management
when using the server in standalone mode.
Note
Server Default Settings
The server is shipped with these default settings:
• The NIC mode is Dedicated (the only supported option in APIC).
• The NIC redundancy is None for Dedicated NIC mode.
• DHCP is enabled.
• IPv4 is enabled.
Connection Methods
There are two methods for connecting to the system for initial setup:
• Local setup—Use this procedure if you want to connect a keyboard and monitor directly to the system
for setup. This procedure can use a KVM cable (Cisco PID N20-BKVM) or the ports on the rear of the
server.
Cisco APIC M4/L4 Server Installation and Service Guide
26
Installing the Server
Initial Server Setup

Cisco APIC M4 Specifications

General

Brand	Cisco
Model	APIC M4
Category	Server
Language	English