Cisco ASA 5508-X - Page 9

DescriptionLED
System operating status:
• Green – Normal system function.
• Amber – Critical alarm indicating one or more of the following:
•
Major failure of a hardware or software component.
•
Over-temperature condition.
•
Power voltage outside the tolerance range.
Status
Status of the failover pair:
• Solid green – Failover pair operating normally.
• Unlit – Failover is not operational.
Active
SSD LED behavior at first customer ship:
• Unlit – No SSD present.
• Green – SSD installed.
SSD LED behavior after June 2017:
• Unlit – No SSD present or no activity on the SSD.
• Green – Activity on the SSD.
See Replace the SSD , on page 27 for information on replacing a failed
SSD.
Note
SSD
Network Port Status
On the rear panel, a pair of LEDs (Link status and connection Status) for each of the eight Gigabit Ethernet
network ports, and the Gigabit Ethernet Management port.
Link status (L):
• Unlit – No link, or port is not in use.
• Solid green – Link established.
• Flashing green – Link activity.
Connection-speed status (S):
• One blink every three seconds – 10 Mbps.
• Two rapid blinks – 100 Mbps.
• Three rapid blinks – 1000 Mbps.
Cisco ASA 5508-X and ASA 5516-X Hardware Installation Guide
Online Only 5
Overview
LEDs