Cisco ASA 5515-X Cli Configuration Guide

1-12
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Logging
Configuring Logging
Sending Syslog Messages to an SNMP Server
To enable logging to an SNMP server, enter the following command:
Sending Syslog Messages to a Telnet or SSH Session
To send syslog messages to a Telnet or SSH session, perform the following steps:
Command Purpose
logging history [logging_list | level]
Example:
hostname(config)# logging history errors
Enables SNMP logging and specifies which messages are to
be sent to SNMP servers. To disable SNMP logging, enter the
no logging history command.
Command Purpose
Step 1
logging monitor {severity_level | message_list}
Example:
hostname(config)# logging monitor 6
Specifies which syslog messages should be sent to a
Telnet or SSH session.
Step 2
terminal monitor
Example:
hostname(config)# terminal monitor
Enables logging to the current session only. If you log
out and then log in again, you need to reenter this
command. To disable logging to the current session,
enter the terminal no monitor command.

Cisco ASA 5515-X Specifications

General

Firewall Throughput	1.2 Gbps
Maximum Concurrent Sessions	250, 000
VPN Throughput	200 Mbps
Maximum VPN Peers	250
Interfaces	6 x Gigabit Ethernet
IPsec VPN Throughput	200 Mbps
Memory	4 GB
Flash Memory	4 GB
Form Factor	1RU
IPS Throughput	250 Mbps
Concurrent Sessions	250, 000
Security Contexts	2
Power Supply	AC power supply (100-240V)