EasyManuals Logo

Cisco ASA 5545-X Configuration Guide

Cisco ASA 5545-X
428 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #308 background imageLoading...
Page #308 background image
13-34
Cisco ASA Series Firewall CLI Configuration Guide
Chapter 13 Inspection of Basic Internet Protocols
IPv6 Inspection
Configure IPv6 Inspection
IPv6 inspection is not enabled by default. You must configure it if you want IPv6 inspection.
Procedure
Step 1 Configure an IPv6 Inspection Policy Map, page 13-34.
Step 2 Configure the IPv6 Inspection Service Policy, page 13-35.
Configure an IPv6 Inspection Policy Map
To identify extension headers to drop or log, or to disable packet verification, create an IPv6 inspection
policy map to be used by the service policy.
Procedure
Step 1 Create an IPv6 inspection policy map.
hostname(config)# policy-map type inspect ipv6 policy_map_name
hostname(config-pmap)#
Where the policy_map_name is the name of the policy map. The CLI enters policy-map configuration
mode.
Step 2 (Optional) Add a description to the policy map.
hostname(config-pmap)# description string
Step 3 (Optional) Drop or log traffic based on the headers in IPv6 messages.
a. Identify the traffic based on the IPv6 header.
hostname(config-pmap)# match header type
Where type is one of the following:
• ah—Matches the IPv6 Authentication extension header.
• count gt number—Specifies the maximum number of IPv6 extension headers, from 0 to 255.
• destination-option—Matches the IPv6 destination-option extension header.
• esp—Matches the IPv6 Encapsulation Security Payload (ESP) extension header.
• fragment—Matches the IPv6 fragment extension header.
• hop-by-hop—Matches the IPv6 hop-by-hop extension header.
• routing-address count gt number—Sets the maximum number of IPv6 routing header type 0
addresses, greater than a number between 0 and 255.
• routing-type {eq | range} number—Matches the IPv6 routing header type, from 0 to 255. For
a range, separate values by a space, for example, 30 40.
b. Specify the action to perform on matching packets. You can drop the packet and optionally log it,
or just log it. If you do not enter an action, the packet is logged.
hostname(config-pmap)# {drop [log] | log}

Table of Contents

Other manuals for Cisco ASA 5545-X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASA 5545-X and is the answer not in the manual?

Cisco ASA 5545-X Specifications

General IconGeneral
Power SupplyDual, Hot-swappable
Memory8 GB
Flash Memory8 GB
AC Input Voltage100-240 VAC
Form Factor1 RU
Number of VLANs1024
Security Contexts50
Interfaces8 x Gigabit Ethernet
Frequency50-60 Hz
Dimensions (H x W x D)1.75 x 17.5 x 12 in (4.4 x 44.5 x 30.5 cm)
High AvailabilityActive/Standby
StorageSSD (optional)

Related product manuals