Figure 26: Locking the Power Retainer Cord
Step 4 Connect the other end of the power cord to an AC-input power source.
Step 5 Verify power supply operation by checking that the power supply LED is green.
Step 6 If the LEDs indicate a power problem, see LED Indicators section for troubleshooting information.
Step 7 If you are installing a redundant power supply, repeat these steps for the second power source.
If you are installing a redundant AC power supply, ensure that each power supply is connected to
a separate power source in order to prevent power loss in the event of a power failure.
Note
Removing and Replacing an AC Power Supply
This section describes how to remove and replace an AC power supply.
Installing the Router
32
Installing the Router
Removing and Replacing an AC Power Supply
To Next Page
Loading...
Need help?
General
