Cisco ASR 920 series Installing Guide

If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp latch is obstructed
and you cannot use your index finger to open it, use a small, flat-blade screwdriver or other long, narrow instrument to
open the bale-clasp latch.
Figure 19: Removing a Bale-Clasp Latch SFP Module
Step 4
Grasp the SFP module between your thumb and index finger, and carefully remove it from the module slot.
Step 5
For fiber-optic SFP modules, insert a dust plug into the optical ports of the SFP module to keep the optical interfaces
clean.
Step 6
Place the removed SFP module in an antistatic bag or other protective environment.
Connect to the 10/100/1000 Ports
The router 10/100/1000 ports configure themselves to operate at the speed of attached devices. If the
attached ports do not support autonegotiation, you can explicitly set the speed and duplex parameters.
Connecting devices that do not autonegotiate or that have their speed and duplex parameters manually set
can reduce performance or result in no linkage.
Note
To maximize performance, choose one of these methods for configuring the Ethernet ports:
Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide
23
Installing the Cisco ASR 920 Series Router
Connect to the 10/100/1000 Ports

Cisco ASR 920 series Specifications

General

Brand	Cisco
Model	ASR 920 series
Category	Network Router
Language	English