Cisco ASR 920 series - Connect Cable to Copper Gigabit Ethernet Port

To Next Page

To Previous Page

Connect Cable to Copper Gigabit Ethernet Port

The device interface modules support RJ-45 and Ethernet SFP ports.

The RJ-45 port supports standard straight-through and crossover Category 5 unshielded twisted-pair (UTP)

cables. Cisco does not supply Category 5 UTP cables. These cables are available commercially.

SUMMARY STEPS

1. Confirm that the device is powered off.

2. Connect one end of the cable to the Gigabit Ethernet port on the device.

3. Connect the other end to the BTS patch or demarcation panel at your site.

DETAILED STEPS

Step 1 Confirm that the device is powered off.

Step 2 Connect one end of the cable to the Gigabit Ethernet port on the device.

Step 3 Connect the other end to the BTS patch or demarcation panel at your site.

You have successfully installed the device and you are now ready to carry out a basic device configuration.

Connect Cables to SFP Modules

For information on connecting cables to Cisco optical and Ethernet SFP interfaces, see:

http://www.cisco.com/en/US/partner/products/hw/modules/ps5455/prod_installation_guides_list.html.

Connector and Cable Specifications

For more information on cable specifications and pinouts, see Chapter 5, “Troubleshooting” .

Installing the Cisco ASR 920 Series Router

Connect Cable to Copper Gigabit Ethernet Port

Other manuals for Cisco ASR 920 series