Step 6 Reset RSP880 card. Now the RSP880 becomes the standby RSP in slot 0 and synchronizes configuration
from active RSP440 in slot 1.
Example:
rommon B1> reset –h
The RSP880 reloads and the user is disconnected from ROMMON automatically.
Note
Step 7 Wait until standby node reaches NSR-ready state and status of ALL the groups is Ready state. Use show
redundancy command to verify the same.
Example:
Router# show redundancy
Tue Nov 18 07:51:47.098 EDT
Redundancy information for node 0/RSP0/CPU0:
==========================================
Node 0/RSP1/CPU0 is in ACTIVE role
Node Redundancy Partner (0/RSP0/CPU0) is in STANDBY role
Standby node in 0/RSP0/CPU0 is ready
Standby node in 0/RSP0/CPU0 is NSR- ready
Node 0/RSP1/CPU0 is in process group PRIMARY role
Process Redundancy Partner (0/RSP0/CPU0) is in BACKUP role
Backup node in 0/RSP0/CPU0 is ready
Backup node in 0/RSP0/CPU0 is NSR-ready
Group Primary Backup Status
--------- --------- --------- ---------
dsc 0/RSP1/CPU0 0/RSP0/CPU0 Ready
dlrsc 0/RSP1/CPU0 0/RSP0/CPU0 Ready
central-services 0/RSP1/CPU0 0/RSP0/CPU0 Ready
v4- routing 0/RSP1/CPU0 0/RSP0/CPU0 Ready
netmgmt 0/RSP1/CPU0 0/RSP0/CPU0 Ready
mcast-routing 0/RSP1/CPU0 0/RSP0/CPU0 Ready
v6-routing 0/RSP1/CPU0 0/RSP0/CPU0
Step 8 From the active RSP, verify that both RSPs have synchronized the SNMP engine ID and SNMP ifindex-table
between each other:
Example:
#more disk0:snmp/ifindex-table loc 0/rsp0/cpu0
#more disk0:snmp/ifindex-table loc 0/rsp1/cpu0
#more disk0:snmp/snmp_persist loc 0/rsp0/cpu0
#more disk0:snmp/snmp_persist loc 0/rsp1/cpu0
Step 9 Manually copy Embedded Event Manager (EEM) scripts from RSP440 to RSP880 disks if applicable.
The EEM scripts are files located on RSP’s hard disk. These files are not automatically synced
between Active and Standby RSPs.
Note
Step 10 Perform redundancy switchover from active RSP440 (slot 1) to standby RSP880 in (slot 0)
Example:
Router# redundancy switchover
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
255
Replacing Cisco ASR 9000 Series Router Components
Migrating from RSP440 to RSP880 or RSP880-LT Card
To Next Page
Loading...
Need help?
General
