6
Step 3: 3G Status Conrmation
Power
*
Solid Green
Ethernet
*
Solid Green
A
GPS
Solid Green
A
Computer
Option A: O
Option B: Solid Green or Flashing Green (during Data Transfer)
3G
Solid Green
3G Status Conrmation
2. After 90 minutes, look at your 3G MicroCell front panel status indicators.
• If the 3G status indicator is solid green ,
3G activation is complete. You may
advance to Step 4: Final Conrmation .
• If the 3G status indicator is still ashing
after 90 minutes , refer to the steps
below for solutions to try.
*
If the Power or Ethernet status indicators are not solid green, see the Troubleshooting section on page 14 in the AT&T 3G
MicroCell™ User Manual for more information.
1. Make sure the Power and Ethernet status indicators are solid green *. If you chose Option B, the Computer status
indicator will be solid green or ashing green during data transfer.
3G Status Indicator Still Flashing after 90 Minutes?
Try these steps in this order:
1. Conrm that
at least 90 minutes have passed since rst powering up the 3G MicroCell.
2. Power cycle your 3G MicroCell. (Unplug the power adapter from the wall outlet, wait 10 seconds, then plug it back in.)
Wait 30 minutes for 3G indicator to go solid green .
3. If power cycling doesn’t resolve the problem, see Option C on page 11 in the AT&T 3G MicroCell™ User Manual for an
alternative cabling conguration that may provide a solution.
4. If your 3G status indicator still fails to go solid green, see the Troubleshooting section on page 14 in the AT&T 3G
MicroCell™ User Manual , or contact AT&T Customer Support at 1.800.768.1212 for assistance.
Wait 90 minutes. You have completed your part. Relax and give your 3G MicroCell time to
complete system conguration and 3G service activation. Do not turn o power or disconnect.
Note: The GPS and 3G status indicators will start ashing green within 10 minutes .