On the Create a Disk page, select Disk Size as , Disk Provisioning as
and click .
Because VM performance may degrade during the resizing of a partition, Thin provision is not
recommended.
On the Advanced Options page, select appropriate options and click .
On the Ready to Complete page, confirm your deployment settings and click .
Once the VM is created, right click on the newly created VM, select Power and click
.
Install Windows Server 2012 Standard on this newly created VM.
To configure the IP information, enter the following in the relevant fields. Configure other
entries as required.
IP address—
Subnet mask—
Default gateway—
DNS server—
Complete all critical windows update, close all open applications and disable virus-scanning
software and other software that may prevent an installation from completing.
To Next Page
Loading...
