Cisco C220 M3

To Next Page

Server Setup

This chapter provides instructions for setting up the server. It includes the following topics:

• Connect Power Supplies and KVM Adapter, on page 1

• Network Interface Connections Setup, on page 1

• Network Interface Setup Diagram, on page 4

• Firewall Rules, on page 5

• Power On and Boot Up Appliance, on page 8

Connect Power Supplies and KVM Adapter

To begin, connect both power supplies on the back of your appliance. Connect the included KVM adapter to

an external monitor and keyboard, and plug into the KVM port located at the front of the server, as illustrated

in Figure 3.

If CIMC is configured, you can use a remote KVM. See CIMC Configuration.

Refer to the server product documentation for detailed hardware and environmental setup information (See

Product Documentation).

Network Interface Connections Setup

The SFP+ modules must be connected to the chassis before the appliance is powered on for the session in

which the configuration wizard is going to be run. However, wiring the SFP up to the network can be done

between power on and configuration.

For Threat Grid Appliance (version 2.7.2 or later), only the Threat Grid M5 Appliance is supported. Refer to

the Cisco Threat Grid M5 Appliance Hardware Installation Guide for server setup instructions.

Note

C220 M3 Rack Server Setup

The interfaces must be properly connected and configured for the appliance to operate.

Server Setup

Need help?

Do you have a question about the Cisco C220 M3 and is the answer not in the manual?

Cisco C220 M3 Specifications

General

Maximum Processors	2
Memory Slots	24 DIMM slots
RAID Support	RAID 0, 1, 5, 6, 10, 50, 60
Remote Management	Cisco Integrated Management Controller (CIMC)
Processor	Intel Xeon E5-2600 series
Memory	Up to 768 GB
Network Interfaces	2 x 1GbE ports
Expansion Slots	3 x PCIe 3.0 slots
Power Supply	650W hot-plug redundant
Operating System Support	Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi
Form Factor	1U rack server