Cisco C220 M3 User Manual

For releases 1.0-1.2 a reboot may be needed if an interface was not plugged in at boot time. This is a pre-1.3
issue, except for any interface requiring an SFP, which will still needs to be plugged in at boot time post 1.3.
The network cable plugged into the SFP may be safely hot-plugged.
Note
C220 M4 Rack Server Setup
The interfaces must be properly connected and configured for the appliance to operate.
Use port 3 Slot 2 for the (optional) Clust interface.
The details for your appliance may differ from the illustrations. Contact support@threatgrid.com if you
have any questions.
Note
Figure 3: Cisco UCS C220 M4 SFF Rack Server
Server Setup
3
Server Setup
C220 M4 Rack Server Setup

Cisco C220 M3 Specifications

General

Maximum Processors	2
Memory Slots	24 DIMM slots
RAID Support	RAID 0, 1, 5, 6, 10, 50, 60
Remote Management	Cisco Integrated Management Controller (CIMC)
Processor	Intel Xeon E5-2600 series
Memory	Up to 768 GB
Network Interfaces	2 x 1GbE ports
Expansion Slots	3 x PCIe 3.0 slots
Power Supply	650W hot-plug redundant
Operating System Support	Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi
Form Factor	1U rack server