Cisco C220

Server Setup
This chapter provides instructions for setting up the server. It includes the following topics:
• Connect Power Supplies and KVM Adapter, on page 1
• Network Interface Connections Setup, on page 1
• Network Interface Setup Diagram, on page 4
• Firewall Rules, on page 5
• Power On and Boot Up Appliance, on page 8
Connect Power Supplies and KVM Adapter
To begin, connect both power supplies on the back of your appliance. Connect the included KVM adapter to
an external monitor and keyboard, and plug into the KVM port located at the front of the server, as illustrated
in Figure 3.
If CIMC is configured, you can use a remote KVM. See CIMC Configuration.
Refer to the server product documentation for detailed hardware and environmental setup information (See
Product Documentation).
Network Interface Connections Setup
The SFP+ modules must be connected to the chassis before the appliance is powered on for the session in
which the configuration wizard is going to be run. However, wiring the SFP up to the network can be done
between power on and configuration.
For Threat Grid Appliance (version 2.7.2 or later), only the Threat Grid M5 Appliance is supported. Refer to
the Cisco Threat Grid M5 Appliance Hardware Installation Guide for server setup instructions.
Note
C220 M3 Rack Server Setup
The interfaces must be properly connected and configured for the appliance to operate.
Server Setup
1
All manuals and user guides at all-guides.com

Cisco C220 Specifications

General

Remote Management	Cisco Integrated Management Controller (CIMC)
Product Type	Server
Processor	Intel Xeon E5-2600 v4
Memory	Up to 1.5 TB
Power Supply	Redundant Power Supplies
Network Interface	Dual Gigabit Ethernet
RAID Support	Yes, with RAID controller options

Summary

Server Setup

Connect Power Supplies and KVM Adapter

Connect power supplies and KVM adapter to the server for initial setup and connection.

Network Interface Connections Setup

Connect SFP+ modules and network cables to the chassis before powering on the appliance.

C220 M3 Rack Server Setup

Details for setting up the Cisco C220 M3 Rack Server, ensuring proper interface connections.

C220 M4 Rack Server Setup

Instructions for setting up the Cisco C220 M4 Rack Server, including interface connections.

Network Interface Setup Diagram

Diagram illustrating network interface connections for Cisco UCS C220 M4 servers.

Firewall Rules

This section provides suggested firewall rules for the appliance's network interfaces.

Power On and Boot Up Appliance

Procedure for powering on the appliance and booting up the server for initial use.