Cisco C9200L-48P-4X User Manual

23-inch brackets
(RACK-KIT-T1=)
319-inch brackets
(RACK-KIT-T1=)
1
24-inch brackets
(RACK-KIT-T1=)
4ETSI brackets
(RACK-KIT-T1=)
2
Attaching the Rack-Mount Brackets
Before you begin
You can use the minimum recommended number of two screws for installing the rack-mount bracket to each
side of the switch. If required, while mounting, you can use the additional four screws provided in the accessory
kit.
Procedure
Use two Phillips flat-head screws to attach the long side of the bracket to each side of the switch for the front-
or rear-mounting positions.
The following illustration shows a C9200L switch. C9200 switches follow the same method for installing the
rack mount bracket.
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
22
Installing the Switch
Attaching the Rack-Mount Brackets

Cisco C9200L-48P-4X Specifications

General

Uplink interfaces	4x 10G SFP+
Default power supply	715W AC
PoE power budget	740W
Switching capacity	176 Gbps
DRAM	4 GB
Form Factor	1 RU
Jumbo Frame	9198 bytes
Dimensions	44.5 x 4.4 x 40.2 cm
Operating Temperature	0°C to 45°C
Operating Humidity	5 to 90% relative humidity
Total 10/100/1000 or Multigigabit copper ports	48
Weight	7.26 kg