Cisco Catalyst 9136I Series - Chapter 8 Declarations of Conformity and Regulatory Information; Manufacturers Federal Communication Commission Declaration of Conformity Statement

To Next Page

To Previous Page

CHAPTER 8

Declarations of Conformity and Regulatory

Information

This section provides declarations of conformity and regulatory information for the Cisco Catalyst 9136I

Series Access Points APs. You can find additional information at: http://www.cisco.com/go/aironet/compliance.

• Manufacturers Federal Communication Commission Declaration of Conformity Statement, on page 31

• VCCI Statement for Japan, on page 32

• Canadian Compliance Statement, on page 34

• European Community, Switzerland, Norway, Iceland, and Liechtenstein Compliance, on page 36

• Administrative Rules for Cisco Catalyst Access Points in Taiwan, on page 37

• Operation of Cisco Catalyst Access Points in Brazil, on page 38

• Declaration of Conformity for RF Exposure, on page 38

• Declaration of Conformity Statements, on page 41

ManufacturersFederalCommunicationCommissionDeclaration

of Conformity Statement

Certification NumberAccess Point Models

LDKMU6CR2417C9136I-B

Manufacturer:

Cisco Systems, Inc.170 West Tasman DriveSan Jose, CA 95134-1706USA

This device complies with Part 15 rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference

Cisco Catalyst 9136I Series Access Point Hardware Installation Guide

Other manuals for Cisco Catalyst 9136I Series