Cisco Catalyst 9136I Series User Manual

Performing a PreInstallation Configuration (Optional) 15
Preinstallation Checks and Installation Guidelines 17
Mounting the Access Point 18
Powering the Access Point 20
Redundant Power over Ethernet 20
Configuring and Deploying the Access Point 21
CHAPTER 5
The Controller Discovery Process 21
Deploying the Access Point on the Wireless Network 22
Checking the Access Point LEDs 22
Troubleshooting 25
CHAPTER 6
Using the Mode Button 25
Troubleshooting the Access Point to Cisco Controller Join Process 26
Important Information for Controller-Based Deployments 27
Configuring DHCP Option 43 27
Safety Guidelines and Warnings 29
CHAPTER 7
Safety Instructions 29
Declarations of Conformity and Regulatory Information 31
CHAPTER 8
Manufacturers Federal Communication Commission Declaration of Conformity Statement 31
VCCI Statement for Japan 32
Guidelines for Operating Cisco Catalyst Access Points in Japan 33
Canadian Compliance Statement 34
European Community, Switzerland, Norway, Iceland, and Liechtenstein Compliance 36
Administrative Rules for Cisco Catalyst Access Points in Taiwan 37
Operation of Cisco Catalyst Access Points in Brazil 38
Declaration of Conformity for RF Exposure 38
Generic Discussion on RF Exposure 38
This Device Meets International Guidelines for Exposure to Radio Waves 39
This Device Meets FCC Guidelines for Exposure to Radio Waves 39
This Device Meets the Industry Canada Guidelines for Exposure to Radio Waves 39
Additional Information on RF Exposure 41
Cisco Catalyst 9136I Series Access Point Hardware Installation Guide
iv
Contents

Cisco Catalyst 9136I Series Specifications

General

Brand	Cisco
Model	Catalyst 9136I Series
Category	Wireless Access Point
Language	English