EasyManuals Logo

Cisco Catalyst 9407R Installation Note

Cisco Catalyst 9407R
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
Removing the Switching Module
Hazardous voltage or energy is present on the backplane when the system is operating. Use caution when servicing. Statement
1034
Warning
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or view directly with
optical instruments. Statement 1051
Warning
Before you begin
You will need a blank module filler plate (C9400-S-BLANK) if the module slot is to remain empty.
Procedure
Step 1 Disconnect any network interface cables attached to the module ports.
Step 2 If the module is equipped with removable optical transceivers, immediately install dust plugs into the transceivers optical
bores. This prevents possible dust contamination, which can affect port performance.
Step 3 With a Phillips screwdriver, completely loosen the two captive screws located at each end of the module faceplate.
Step 4 Grasp the left and right ejector levers and simultaneously pivot the levers outward to eject the module from the backplane
connector.
24

Other manuals for Cisco Catalyst 9407R

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 9407R and is the answer not in the manual?

Cisco Catalyst 9407R Specifications

General IconGeneral
ModelCisco Catalyst 9407R
CategorySwitch
Chassis Slots7
Rack Units10 RU
Form FactorRack-mountable
Slots7
Maximum Number of Line Cards5
Operating SystemCisco IOS XE
Product TypeModular Switch
Power Supply OptionsAC and DC
RedundancyYes

Related product manuals