Procedure
Step 1 Attach an ESD-preventive wrist strap to your wrist and to an earth ground surface
Do not remove the network module with connected cables or installed pluggable transceiver
modules. Always remove any cables and modules before you remove the network module.
Caution
A module interface might become error-disabled when a network module with connected
fiber-optic cables is installed or removed. If an interface is error-disabled, you can reenable the
interface by using the shutdown and no shutdown interface configuration commands.
Caution
Step 2 Disconnect the cables from the pluggable transceiver module.
Step 3
Step 4 Release latch and carefully slide the network module out of the slot.
Step 5 Install a replacement network module or a blank module in the slot.
Step 6 Place the module that you removed in an antistatic bag or other protective environment.
Finding the Network Module Serial Number
If you contact Cisco Technical Assistance regarding a network module, you need to know its serial number.
Figure 40: Network Module Serial Number Location
Cisco Catalyst 9500 Series Switches Hardware Installation Guide
60
Installing a Network Module
Finding the Network Module Serial Number
To Next Page
Loading...