Cisco Catalyst C9500-40X User Manual

CHAPTER 3
Preparing for Installation
• Safety Warnings, on page 23
• Site Requirements, on page 25
Safety Warnings
Read the installation instructions before using, installing, or connecting the system to the power source.
Statement 1004
Warning
Class 1 laser product. Statement 1008
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be accessed by
skilled, instructed or qualified personnel. Statement 1017
Warning
This unit might have more than one power supply connection. All connections must be removed to de-energize
the unit. Statement 1028
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning
To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using the handles
on modules (such as power supplies, fans, or cards); these types of handles are not designed to support the
weight of the unit. Statement 1032
Warning
Cisco Catalyst 9500 Series Switches Hardware Installation Guide
23

Cisco Catalyst C9500-40X Specifications

General

Model	C9500-40X
Category	Switch
Product Series	Catalyst 9500
Rack Units	1 RU
Stacking	StackWise Virtual
Software	Cisco IOS XE
DRAM	16 GB
Flash Memory	16 GB
Input Voltage	100 to 240 VAC
Power Consumption	400W
Ports	40 x 10GE
Uplink Ports	4 x 40G/100G QSFP28
Forwarding Rate	1, 440 Mpps
Dimensions	1.73 x 17.5 x 21.52 in. (4.4 x 44.5 x 54.7 cm)