To Next PageTo Next PageHow to change the IP address of my Cisco Catalyst Express 500 Switch after initial setup?
To change the Cisco Switch IP address after the initial setup, go to the Configure > Express Setup device manager screen. For more information about changing the switch IP address, see the User Guide for the Catalyst Express 500 Switches online at Cisco.com.
How to check if PC is connected to the correct port on Cisco Catalyst Express 500?
Verify that you are connected to the switch port with the blinking LED as shown in Step 6.
What to do if I have a pop-up blocker running while connecting my PC to the Cisco Catalyst Express 500?
If you had a pop-up blocker enabled when connecting to the switch port, disconnect the cable from the switch port, disable the pop-up blocker, and then reconnect to the switch. Press the SETUP button to continue.
What to do if proxy settings were enabled when connecting to the Cisco Switch?
If proxy settings were enabled in your browser when you connected to the switch port, disconnect the cable from the switch port, disable the proxy settings, and reconnect to the switch. Press the SETUP button to continue.
What to do if a wireless client was running when connecting to the Cisco Catalyst Express 500 port?
If you had a wireless client running on your PC when you connected to the switch port, disconnect the cable from the switch port, disable the wireless client, and reconnect to the switch. Press the SETUP button to continue.
What to do if I started the browser before the SETUP LED was solid green on my Cisco Catalyst Express 500?
If you started a browser session before the SETUP LED was solid green, restart the Cisco Switch. Then, perform steps 2 through 6. When the SETUP LED is solid green, start a browser session on your PC and complete the set-up procedure.
What if the SETUP LED wasn't blinking when I pressed the SETUP button on my Cisco Switch?
If the SETUP LED was not blinking when you pressed the SETUP button, or if you are unsure, restart the switch. Ensure that the SETUP LED is blinking when you press the SETUP button.
General| Model | Cisco Catalyst Express 500 |
|---|---|
| Category | Switch |
| MAC Address Table Size | 8000 entries |
| RAM | 64 MB |
| Flash Memory | 16 MB |
| Authentication Method | RADIUS, TACACS+ |
| Jumbo Frame Support | Yes |
| Uplink Ports | 2 x combo Gigabit Ethernet |
| PoE Support | Yes |
| Management | Web-based management interface |
| Status Indicators | system |
| Compliant Standards | IEEE 802.3, IEEE 802.3u, IEEE 802.3ab |
| Features | VLAN support, QoS |
| Power Supply | Internal |
| Operating Temperature | 0 to 40 °C |
| Storage Temperature | -20 to 70 °C |
| Relative Humidity | 10% to 85% (non-condensing) |
