How to change the IP address of my Cisco Catalyst Express 500 Switch after initial setup?
To change the Cisco Switch IP address after the initial setup, go to the Configure > Express Setup device manager screen. For more information about changing the switch IP address, see the User Guide for the Catalyst Express 500 Switches online at Cisco.com.
General| Model | Cisco Catalyst Express 500 |
|---|---|
| Category | Switch |
| MAC Address Table Size | 8000 entries |
| RAM | 64 MB |
| Flash Memory | 16 MB |
| Authentication Method | RADIUS, TACACS+ |
| Jumbo Frame Support | Yes |
| Uplink Ports | 2 x combo Gigabit Ethernet |
| PoE Support | Yes |
| Management | Web-based management interface |
| Status Indicators | system |
| Compliant Standards | IEEE 802.3, IEEE 802.3u, IEEE 802.3ab |
| Features | VLAN support, QoS |
| Power Supply | Internal |
| Operating Temperature | 0 to 40 °C |
| Storage Temperature | -20 to 70 °C |
| Relative Humidity | 10% to 85% (non-condensing) |
To Next Page
