•
to strap down cable bundles or conduit (there are multiple tie down points on each strap-down clip)
•
as a base for two snap-on plastic fiber/cable routing guides
Before You Begin
Required Tools and Equipment
•
4 knurled retaining screws
•
T15 Torx driver (optional)
•
2 strap-down clips
•
4 snap-on plastic cable routing guides
Procedure
Step 1
Insert the four knurled retaining screws on the side of the chassis and tighten them using a T15 Torx driver (up to a torque
of 6-8 in-lbs). If the screw location is not accessible for a driver, you can tighten the knurled screws by hand.
16
To Next Page
Loading...
