Cisco CBS 350 Series User Manual

Read these instructions carefully before beginning installation. Failure to use the correct hardware or to follow
the correct procedures could result in a hazardous situation to people and damage to the system.
Caution
Do not wall-mount the switch with its front panel facing up. Following safety regulations, wallmount the
switch with its front panel facing down or to the side to prevent airflow restriction and to provide easier access
to the cables.
Caution
To wall-mount a 24-port switch using brackets:
Step 1 Attach a 19-inch bracket to one side of the switch.
Step 2 Repeat the previous step to attach the other bracket to the opposite side of the switch.
Step 3 After the brackets are securely attached, mount the switch with the front panel facing down. Make sure that the switch
is attached securely to wall studs or to a firmly attached plywood-mounting backboard. Wall-mounting a 24-port switch.
Wall-mounting a 24-port
Wall Mount an 8 Port Switch
To wall-mount a 8-port switch using mounting screws, follow these steps:
Get To Know Your Switch
3
Get To Know Your Switch
Wall Mount an 8 Port Switch

Cisco CBS 350 Series Specifications

General

Model	CBS350 Series
Switch Type	Managed
Dimensions	Varies by model
Weight	Varies by model
Ports	8, 24, 48
Uplink Ports	SFP/SFP+ (depending on model)
PoE	Yes
Layer	Layer 2/3
Switching Capacity	Varies by model (up to 176 Gbps)
Forwarding Rate	Varies by model (up to 131 Mpps)
Energy Efficient Ethernet	Yes
Management	Web-based, CLI, SNMP
Security Features	ACLs, 802.1X, Port Security, DHCP Snooping, IP Source Guard
Features	QoS, VLAN, Link Aggregation, Spanning Tree, IGMP Snooping
MAC Address Table Size	16K entries
Jumbo Frame Support	Yes
Layer 3 Features	Static routing, IPv4/IPv6 routing
Power Supply	Internal
Operating Temperature	0°C
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Humidity	10% to 90% non-condensing
Warranty	Limited Lifetime
Port Speed	10/100/1000 Mbps (depending on model)