Cisco CBS 350 Series User Manual

Step 1 Locate the screw template. The template is used to align the mounting screw holes.
Step 2 Position the screw template so that the edge that is marked as CABLE SIDE ENTRY faces toward the floor. Make sure
that the switch is attached securely to wall studs or to a firmly attached plywoodmounting backboard.
Step 3 Peel the adhesive strip off the bottom of the screw template.
Step 4 Attach the screw template to the wall.
Step 5 Use a 0.144-inch (3.7 mm) or a #27 drill bit to drill a 1/2-inch (12.7 mm) hole in the two screw template slots.
Step 6 Insert two screws in the slots on the screw template, and tighten them until they touch the top of the screw template.
Installing the mounting screws on the wall
Figure 3 Installing the mounting screws on the wall
Step 7 Remove the screw template from the wall.
Step 8 Place the switch onto the mounting screws, and slide it down until it locks in place.Wall-mounting an 8-port switch
Figure 4 Wall-mounting an 8-port switch
Get To Know Your Switch
4
Get To Know Your Switch
Wall Mount an 8 Port Switch

Cisco CBS 350 Series Specifications

General

Model	CBS350 Series
Switch Type	Managed
Dimensions	Varies by model
Weight	Varies by model
Ports	8, 24, 48
Uplink Ports	SFP/SFP+ (depending on model)
PoE	Yes
Layer	Layer 2/3
Switching Capacity	Varies by model (up to 176 Gbps)
Forwarding Rate	Varies by model (up to 131 Mpps)
Energy Efficient Ethernet	Yes
Management	Web-based, CLI, SNMP
Security Features	ACLs, 802.1X, Port Security, DHCP Snooping, IP Source Guard
Features	QoS, VLAN, Link Aggregation, Spanning Tree, IGMP Snooping
MAC Address Table Size	16K entries
Jumbo Frame Support	Yes
Layer 3 Features	Static routing, IPv4/IPv6 routing
Power Supply	Internal
Operating Temperature	0°C
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Humidity	10% to 90% non-condensing
Warranty	Limited Lifetime
Port Speed	10/100/1000 Mbps (depending on model)