Cisco CRS-1 - Carrier Routing System Router

4-58
Cisco CRS-1 Series Carrier Routing System XML API Guide
OL-4596-01
Chapter 4 Cisco CRS-1 Series XML and Native Data Operations
Native Data Operation Content
<Naming>
<AF>IPv4Unicast</AF>
</Naming>
<Activate>true</Activate>
<PrefixListFilterIn>orf</PrefixListFilterIn>
<AdvertiseORF>Both</AdvertiseORF>
</NeighborAF>
<NeighborAF>
<Naming>
<AF>IPv4Multicast</AF>
</Naming>
<Activate>true</Activate>
<PrefixListFilterIn>orf</PrefixListFilterIn>
</NeighborAF>
</NeighborAFTable>
</Neighbor>
</NeighborTable>
</BGPEntity>
</AS>
</BGP>
</Configuration>
</Set>
</Request>
Sample XML Response from the Cisco CRS-1 Series Router
<?xml version="1.0" encoding="UTF-8"?>
<Response MajorVersion="1" MinorVersion="0">
<Set>
<Configuration/>
</Set>
</Response>
Get Request: Example
The following example shows a native data request to get the address independent configuration values
for a specified BGP neighbor (using the same values set in the previous example).
Sample XML Client Request to <Get> Configuration Values for a BGP Neighbor
<?xml version="1.0" encoding="UTF-8"?>
<Request MajorVersion="1" MinorVersion="0">
<Get>
<Configuration>
<BGP MajorVersion="1" MinorVersion="0">
<AS>
<Naming>
<AS>3</AS>
</Naming>
<BGPEntity>
<NeighborTable>
<Neighbor>
<Naming>
<IPAddress>
<IPV4Address>10.0.101.6</IPV4Address>
</IPAddress>
</Naming>
</Neighbor>
</NeighborTable>
</BGPEntity>
</AS>
</BGP>