Chapter 3 Configuring the DOCSIS Residential Gateway
Setup Advanced Settings - VPN Setup Page Description
This section describes the section headings and field descriptions of the Setup
Advanced Settings - VPN Setup page. This page allows you to create, configure, and
control IPsec VPN tunnels.
Tunnel Section
Displays existing tunnels and allows each tunnel to be individually
configured.
Displays the name of a group of settings for a single tunnel. If no name
is entered, the tunnels are named sequentially 1, 2, 3, and so on.
Enables/disables a VPN tunnel after the tunnel is named and
configured. Click Apply to activate the selected setting (Enabled or
Disabled).
Function Keys
The following table describes the function keys associated with the Tunnel section of
the VPN Setup page.
Allows you to delete a tunnel.
Allows you to create a heading for the tunnel settings that you can
select using the Tunnel drop-down menu.
Activates the selected setting (Enabled or Disabled).
Local Endpoint Settings
The following table describes the fields in the Local endpoint settings section of the
VPN Setup page.
Allows you to select the address group type for the local VPN access
group. The following types are available:
IP subnet
Single IP address
IP address range
Allows you to enter Subnet information based on the selected
Address group type as follows:
For IP subnet, enter the subnet.
For single IP address, enter only the specific IP address.
For IP address range, enter the starting and ending IP addresses.
To Next Page
Loading...
