Cisco DPC2320 DOCSIS - Page 73

Configure Advanced Settings
4042831 Rev A 55
Field Name
Description
Mask
Allows you to enter Mask information based on the selected Address
group type as follows:

For IP subnet, enter the subnet mask.

For single IP address, enter only the specific IP address in the
Subnet field. Leave this field blank.

For IP address range, enter the starting IP and ending IP
addresses.
Identity type
Allows you to select the local Identity type from one of the following
options:

WAN IP address of the router (default)

User-specified IP address

Fully qualified domain name (FQDN)

Email address
This is the identity that the far endpoint will use for identification of
the VPN termination point. The remote VPN endpoint on the other
end of the tunnel should match these settings for its remote endpoint
settings.
Identity
Allows you to enter the identity string after you have selected the
identity type using one of the following formats:

For IP address mode, use the format xxx.xxx.xxx.xxx.

For FQDN, use the format "yourdomain.com."

For email address, use the format "yourname@yourdomain.com."
The remote VPN endpoint on the other end of the tunnel should
match these settings for its remote endpoint settings.