Cisco DPC2320 DOCSIS - Page 74

Chapter 3 Configuring the DOCSIS Residential Gateway
56 4042831 Rev A
Remote Endpoint Settings
These settings control how the local endpoint (router) connects to the far VPN
termination point (the other end of the VPN tunnel).
Field Name
Description
Address group type
Allows you to select the address group type for the remote VPN
access group. The following types are available:

IP subnet

Single IP address

IP address range
The remote VPN endpoint on the other end of the tunnel should
match these settings for its remote endpoint settings.
Subnet
Allows you to enter Subnet information based on the selected
Address group type as follows:

For IP subnet, enter the subnet.

For single IP address, enter only the specific IP address.

For IP address range, enter the starting and ending IP addresses.
Mask
Allows you to enter Mask information based on the selected Address
group type as follows:

For IP subnet, enter the subnet mask.

For single IP address, enter only the specific IP address in the
Subnet field. Leave this field blank.

For IP address range, enter the starting IP and ending IP
addresses.
Identity type
Allows you to select the remote Identity type from one of the
following options:

WAN IP address of the router (default)

User-specified IP address

Fully qualified domain name (FQDN)

Email address
This is the identity that the far endpoint will use for identification of
the VPN termination point. The remote VPN endpoint on the other
end of the tunnel should match these settings for its remote endpoint
settings.