Step 3
Synchronize your modem:
This synchronization may take approximately 10 minutes to complete.
a. Wait until the following three indicator lights on the front of your
modem are blinking: DS, US, and ONLINE.
b. Please proceed to Step 4 when the three indicator lights on the
modem are blinking.
c. If you do not see the correct indicator light pattern, please refer to the
troubleshooting section of this guide.
Note: If a modem rmware upgrade is required, the modem will
automatically detect this and the indicator light timing sequence will start
a second time.
Instructions for
installing and activating
your AC DPC3848
wireless Internet modem
Before you begin
Please read the following instructions before proceeding with your
installation.
Step 1
Take note of the following information, which will be required to activate
your modem.
• Modem serial number
• Modem MAC address number
• Choose a name for your personal wireless network (SSID) –
Max. 32 characters
• Choose a password for your personal wireless network –
Max. 63 characters
The serial number (S/N) and the MAC address are on the back of the
modem as shown:
Please enter the information here before starting:
Modem’s serial number:
Modem’s MAC address number:
Step 2
Modem Connection:
a. Locate an active unused coaxial
walljack.
b. Connect the coaxial cable provided in
the box from the wall outlet to the modem’s coaxial wall jack at the
rear of your modem.
c. Connect the modem’s power cord to a power outlet and to the power
supply socket at the rear of your modem. This will start the modem
synchronization process.
MAC Address
Serial number
Front view of
theequipment
Rear view of
theequipment
Cable connector
Power
DS
US
Online
2.4G
5G
Power
connector
To Next Page
General
