4021196 Rev A 35
Configure Wireless Settings
Configure Wireless Settings
This section describes the options available from the Wireless pages that you can use
to configure the parameters of the WAP to meet your specific requirements and
needs.
Wireless > Basic Settings
Setting up your residential gateway for wireless communication provides you with
the freedom to connect to the Internet from any location within range of the WAP
without having to use wired connections. Select the Basic Settings tab to open the
Wireless Basic Settings page.
The Wireless Basic Settings page allows you to choose your wireless network mode
and other basic features.
Wireless Network: Enable or Disable
Wireless Configuration: Manual or Wi-Fi Protected Setup
Network Mode
Radio Band
Channel Width
Standard Channel
Wireless Network Name (SSID)
Wi-Fi Protected Setup (WPS)
When you select Wi-Fi Protected Setup as your wireless configuration, many settings
will be pre-configured. WPS allows simplified setup that allows you to easily
attached new WPA-enabled devices to your network.
Important: When using WPS mode, WEP is not supported. If you must use WEP
encryption, WPS must be disabled by setting the Wireless Configuration to Manual.
Note: WPS is the default setting.
To Next Page
Loading...
Need help?
General
