Cisco EPC3825 - Page 72

72 4021196 Rev C
Configure Applications and Gaming
Applications & Gaming > Port Range Triggering
Port range triggering is a way to dynamically forward ports to a LAN PC that needs
them at a particular time. That particular time is when it runs a certain application
that performs some event that trigger the router. This event must be an outbound
access of a particular port range.
Select the Port Range Triggering tab to open the Applications & Gaming Port Range
Triggering page.
Applications and Gaming Port Range Triggering Page Description
Use the descriptions and instructions in the following table to configure the port
range triggering for the residential gateway. Select enable for each. After you make
your selections, click Save Settings to apply your changes or Cancel Changes to
cancel.
Section
Field Description
Port Range Triggering
Triggered Range
Start Port
For the Start port, select a port from the recommended 49152 -
65535 range. Keep in mind that ports used are program specific
so check which ones the program requires to be forwarded.
End Port
For the End port, select a port from the recommended 49152 -
65535 range. Keep in mind that ports used are program specific
so check which ones the program requires to be forwarded.
Forwarded Range
Start Port
For the Start port, select a port from the recommended 49152 -
65535 range. Keep in mind that ports used are program specific
so check which ones the program requires to be forwarded.