If you see the below error, you may have entered the package name, instead of the package
version:
Invalid software pack
Please contact technical support for help
Note
Example:
firepower 2110 /firmware # scope auto-install
firepower-2110 /firmware/auto-install # install security-pack version 6.3.0-1
The system is currently installed with security software package 9.10.0.1, which has:
- The platform version: 2.5.1.52
- The CSP (asa) version: 9.10.1.1
If you proceed with the upgrade 6.3.0-1, it will do the following:
- upgrade to the new platform version 2.5.1.78
- reimage the system from CSP asa version 9.10.1.1 to the CSP ftd version 6.3.0.1
Do you want to proceed ? (yes/no): yes
This operation upgrades firmware and software on Security Platform Components
Here is the checklist of things that are recommended before starting Auto-Install
(1) Review current critical/major faults
(2) Initiate a configuration backup
Attention:
If you proceed the system will be re-imaged. All existing configuration will be lost,
and the default configuration applied.
Do you want to proceed? (yes/no): yes
Triggered the install of software package version 6.3.0-1
Install started. This will take several minutes.
For monitoring the upgrade progress, please enter 'show' or 'show detail' command.
firepower-2110 /firmware/auto-install #
Step 6 Wait for the chassis to finish rebooting.
FXOS comes up first, but you still need to wait for the FTD to come up.
After the application comes up and you connect to the application, you are prompted to accept the EULA and
perform initial setup at the CLI. You can use either Firepower Device Manager or Firepower Management
Center to manage your device. See the Quick Start Guide for your model and your manager to continue setup:
http://www.cisco.com/go/ftd-asa-quick
Example:
[...]
************ Attention *********
Initializing the configuration database. Depending on available
system resources (CPU, memory, and disk), this may take 30 minutes
or more to complete.
************ Attention *********
Executing S09database-init [ OK ]
Executing S11database-populate
Cisco FPR Series Security Appliance
Cisco ASA and Firepower Threat Defense Reimage Guide
8
Cisco ASA and Firepower Threat Defense Reimage Guide
ASA→FTD: Firepower 2100 Platform Mode
To Next Page
Loading...
