Statement 1047—Overheating Prevention
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of: 40°C
Warning
This procedure describes how to install the Firepower 2100 series in a rack using the rack kit. It applies to all
models of the 2100 series. For the 2110/2120, you install 3 screws on the chassis to secure the slide rail. For
the 2130/2140, you install use the pegs on the chassis to secure the slide rail.
Before You Begin
You need the following to install the Firepower 2100 in a rack (4-post EIA-310-D rack):
•
#1 Phillips Head screwdriver
•
Firepower 2100 kit that contains the following:
◦
One slide rail set
◦
Two brackets with captive screws
◦
Six 8-32 0.25" screws
◦
Two M3x6mm screws
◦
Six 8-32" shoulder screws
Cisco Firepower 2100 Series Hardware Installation Guide
34
Mount and Connect
Rack-Mount the Chassis
To Next Page
Loading...
