Cisco Firepower 2120

CHAPTER 4
Maintenance and Upgrades
This chapter contains procedures for maintaining and upgrading the Firepower 2100 security appliance, and
contains the following sections:
•
Remove and Replace the Network Module, page 43
•
Remove and Replace the SSD, page 45
•
Remove and Replace the Power Supply Module, page 46
•
Connect the DC Power Supply Module, page 48
•
Secure the Power Cord on the Power Supply Module, page 51
•
Remove and Replace the Fan Tray, page 54
•
Install the Optional Cable Management Brackets, page 55
Remove and Replace the Network Module
Take note of the following warnings:
Statement 1030—Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1073—No User-Serviceable Parts
No user-serviceable parts inside. Do not open.
Warning
You can remove and replace the network module in the Firepower 2130 and 2140. Although the hardware
supports removing and replacing the network module while the system is running, the software does not
Cisco Firepower 2100 Series Hardware Installation Guide
43