Step 9 (Optional) Add labels to your device to help sort and filter the Inventory page. Enter a label and select the
blue plus button ( ). Labels are applied to the device after it's onboarded to CDO.
What to do next
From the Inventory page, select the device you just onboarded and select any of the option listed under the
Management pane located to the right.
Deploy the Firewall With the Onboarding Wizard
This section describes how to configure the firewall for onboarding using the CDO onboarding wizard.
Cable the Firewall
This topic describes how to connect the Firepower 1010 to your network so that it can be managed by CDO.
Figure 44: Cabling the Firepower 1010
You can connect to CDO on the outside interface or the Management interface, depending on which interface
you set for manager access during initial setup. This guide shows the outside interface.
Ethernet1/2 through 1/8 are configured as hardware switch ports; PoE+ is also available on Ethernet1/7
and 1/8.
Note
Cisco Firepower 1010 Getting Started Guide
133
Threat Defense Deployment with CDO
Deploy the Firewall With the Onboarding Wizard
To Next Page
Loading...
