(Optional) Check the Software and Install a New Version, on page 124.CLI
Log Into CDO, on page 125.CDO
Install the firewall. See the hardware installation guide.Physical Tasks
Cable the Firewall, on page 133.Physical Tasks
Power on the Firewall, on page 134.Physical Tasks
Onboard a Device with the Onboarding Wizard, on page 135.CDO
• Perform Initial Configuration Using the CLI, on page 136.
• Perform Initial Configuration Using the Device Manager, on page 141.
CLI or Device Manager
Configure a Basic Security Policy, on page 145.CDO
Central Administrator Pre-Configuration
This section describes how to obtain feature licenses for your firewall; how to install a new software version
before you deploy; and how to log into CDO.
Obtain Licenses
All licenses are supplied to the threat defense by CDO. You can optionally purchase the following feature
licenses:
• IPS—Security Intelligence and Next-Generation IPS
• Malware Defense—Malware defense
• URL—URL Filtering
• Cisco Secure Client—Secure Client Advantage, Secure Client Premier, or Secure Client VPN Only
• Carrier—Diameter, GTP/GPRS, M3UA, SCTP
For a more detailed overview on Cisco Licensing, go to cisco.com/go/licensingguide
Before you begin
• Have a master account on the Smart Software Manager.
Cisco Firepower 1010 Getting Started Guide
122
Threat Defense Deployment with CDO
Central Administrator Pre-Configuration
To Next Page
Loading...
