EasyManuals Logo

Cisco FPR1010-ASA-K9 User Manual

Cisco FPR1010-ASA-K9
192 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #169 background imageLoading...
Page #169 background image
CHAPTER 6
ASA Deployment with ASDM
Is This Chapter for You?
To see all available operating systems and managers, see Which Operating System and Manager is Right for
You?, on page 1. This chapter applies to ASA using ASDM.
This chapter does not cover the following deployments, for which you should refer to the ASA configuration
guide:
Failover
CLI configuration
This chapter also walks you through configuring a basic security policy; if you have more advanced
requirements, refer to the configuration guide.
About the Firewall
The hardware can run either threat defense software or ASA software. Switching between threat defense and
ASA requires you to reimage the device. You should also reimage if you need a different software version
than is currently installed. See Reimage the Cisco ASA or Firepower Threat Defense Device.
The firewall runs an underlying operating system called the Secure Firewall eXtensible Operating System
(FXOS). The firewall does not support the FXOS Secure Firewall chassis manager; only a limited CLI is
supported for troubleshooting purposes. See the Cisco FXOS Troubleshooting Guide for the Firepower
1000/2100 and Secure Firewall 3100 with Firepower Threat Defense for more information.
Privacy Collection Statement—The firewall does not require or actively collect personally identifiable
information. However, you can use personally identifiable information in the configuration, for example for
usernames. In this case, an administrator might be able to see this information when working with the
configuration or when using SNMP.
About the ASA, on page 168
End-to-End Procedure, on page 170
Review the Network Deployment and Default Configuration, on page 172
Cable the Device, on page 175
Power On the Firewall, on page 176
(Optional) Change the IP Address, on page 177
Log Into the ASDM, on page 178
Configure Licensing, on page 179
Configure the ASA, on page 184
Access the ASA and FXOS CLI, on page 186
Cisco Firepower 1010 Getting Started Guide
167

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco FPR1010-ASA-K9 and is the answer not in the manual?

Cisco FPR1010-ASA-K9 Specifications

General IconGeneral
ModelFPR1010-ASA-K9
CategoryFirewall
Maximum VPN Peers50
Power SupplyAC
Memory4 GB
Flash Memory16 GB
IPS Throughput250 Mbps
Operating SystemCisco ASA
Concurrent Connections50, 000
Interfaces8 x 1G Ethernet

Related product manuals