Figure 19: License Search
If a PID is not found, you can add the PID manually to your order.
Note
• IPS, Malware Defense, and URL license combination:
• L-FPR1010T-TMC=
When you add one of the above PIDs to your order, you can then choose a term-based subscription
corresponding with one of the following PIDs:
• L-FPR1010T-TMC-1Y
• L-FPR1010T-TMC-3Y
• L-FPR1010T-TMC-5Y
• Cisco Secure Client—See the Cisco Secure Client Ordering Guide.
• Carrier license:
•
Step 2 If you have not already done so, register the management center with the Smart Software Manager.
Registering requires you to generate a registration token in the Smart Software Manager. See the management
center configuration guide for detailed instructions. For Low-Touch Provisioning, you must enable Cloud
Assistance for Low-Touch Provisioning either when you register with the Smart Software Manager, or after
you register. See the System > Licenses > Smart Licenses page.
Register the Threat Defense with the Management Center
Register the threat defense to the management center.
Before you begin
• Gather the following information that you set in the threat defense initial configuration:
• The threat defense management IP address or hostname, and NAT ID
• The management center registration key
Cisco Firepower 1010 Getting Started Guide
66
Threat Defense Deployment with a Remote Management Center
Register the Threat Defense with the Management Center
To Next Page
Loading...
