Need help?Do you have a question about the Cisco IE-2000-16PTC-G-E and is the answer not in the manual?
General| Model | IE-2000-16PTC-G-E |
|---|---|
| Product Series | Industrial Ethernet 2000 |
| Power Over Ethernet (PoE) | Yes |
| Layer | Layer 2 |
| Weight | 0.9 kg |
| Routing Protocol | Static Routing |
| IP Rating | IP30 |
| Device Type | Switch |
| Enclosure Type | DIN Rail Mountable |
| Subtype | Ethernet Switch |
| Operating Temperature | -40 to 75°C |
| MAC Address Table Size | 8K |
| Remote Management Protocol | SNMP |
| Features | Quality of Service (QoS), VLAN, IGMP snooping, Rapid Spanning Tree Protocol (RSTP) |
| Compliant Standards | IEEE 802.3, IEEE 802.3u, IEEE 802.3ab |
| Mounting | DIN Rail, Wall |
| Security Features | SSH |
| Management | Web-Based Management |
| Certifications | CE |
Covers pre-installation steps, including safety warnings and guidelines.
Lists critical warnings related to switch installation and handling.
Covers tools, supported power supplies, and procedures for connecting power.
Describes physical installation methods, such as mounting on a DIN rail.
Provides steps to confirm the switch is installed and operating correctly.
Methods for identifying and diagnosing switch issues using LEDs and statistics.
Troubleshooting steps for failures during the switch boot process.
Explains how to interpret switch LEDs for troubleshooting.
Addresses issues related to cables, links, and port connectivity.
Procedures for resetting the switch to defaults and recovering lost passwords.
Lists the standards applied for hazardous location approvals and certifications.
Methods to access the Command Line Interface (CLI) via console ports.
Steps for initial switch setup, including IP settings and completing the setup program.
Information required from a network administrator for IP configuration.
Detailed steps to complete the initial configuration wizard and save settings.
To Next Page