3
Product Overview
Linksys WES610N/WET610N
Ports panel
WES610N WET610N
Ethernet The Ethernet port(s) connects the bridge
to a computer or other Ethernet network device. The
WES610N has four ports, and the WET610N has a single
port.
Reset There are two ways to reset the bridge’s factory
defaults. Either press and hold the Reset button for
approximately five seconds, or restore the defaults
from Administration > Factory Defaults in the bridge’s
browser-based utility. The WES610N has a reset button
on the bottom, and the WET610N has a reset button on
the back port panel.
Power The Power port connects the bridge to the
included power adapter.
To Next Page
Loading...
